Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm doing a lab with n9k (n9kv) and VXLAN EVPN fabric. Attached a simple layout. I configured a test l3vni but I'm unable to ping the configured anycast gateway from the vm attached to leaf1 or leaf3 vms can ping each other without problems.
l...
Hello,i've installed two ASA in two offices, all works well but from ASA inside interface i cant' ping my remote networks.The two sites are connected with GRE/IPsec tunnels. From routers i can ping my remote networks (both sides).I've looked in the f...
Hello,i've some problems using PBR on BVI. In my lab (layout attached) on RTR3 i've configured: - BVI with two subinterface (f0/0.10 abd fa0/1.10) with one public IP (BVI10: 1.1.1.4/24) to reach ISP1 router (RTR1)- int fa0/0.255 subinterface to conn...
Hi all,i've set up a vpn between a c877 router and a third party linux box. The tunnel works fine and i'm able to reach both directly connected remote lans.In adds behind the 877 i've an ASA with the outside interface connected directly to 877 router...
ASAs are the default gw for respective LANs. For the point 2 if i trace the packets i can see that their are blocked packet-tracer input inside-g tcp 192.168.1.42 80 192.168.2.31 80Phase: 1Type: ROUTE-LOOKUPSubtype: inputResult: ALLOWConfig:Additiona...
I hope that the jpg attached can clarify my network.- ISRs are the default gateway for both ASA.- If i ping ASA2 outside interface from ASA1 all it's ok, same from ASA2 to ASA1- If i ping a host on 192.168.2.0/24 from router1 it works- If i ping a ho...
yes, a simple diagram ishost1-LAN1--insideASA1outside--ROUTER1------GREtunnel------ROUTER2--outsideASA2inside---LAN2-host2If i ping host2 from host1 all it's ok.If i ping host1 from host2 all it's ok.If i ping host2 from ROUTER1 all it's ok.If i ping...
