Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When configuring a PE router with a XR router there are 3 different type o label allocation and are all clear to me.Just i don't understand when using the MPLS VPN per CE Label (aka label per next-hop) what does actually mean the limitation :"Do not ...
Hi all, has anyone tested a setup where the PE router has imported a VPNV4 prefix where the next hop of this prefix instead of being in the Global routing table was on another VRF. Or even in the same but imported via RT ?
Dear All,i m opening a discussion regarding the QOS as i have read different configuration documents and best practice,but still i have some doubt. I have 3 layer network where the access layer is composed by2960x with 20Gb POconnected to the distrib...
Dear All, I have a scenario where my 2 4500x in VSS are connected via 2 FO links to a Cat 6500.The 6500 is only one box and it has 2 SUP2T.The connection has been configured as a l2 PO and inside the PO , 3 VLAN are propagated (vlan 100, 31 and 32)...
Hi All,i need to perform some network accounting for billing with a network composed by 5 6500 with sup2t. I don't want to enable the netflow as i tried already and seems that is quite buggy [ios version 15.1.2(SY)1 ]https://supportforums.cisco.com/d...
Imagine that between the Middle router there would be an MPLS backbone maintained by another organization and they don't allow me to use that address (just as example) i was thinking to create a vpnv4 like an overlay on top of the MPLS backbone. I di...
Harold, yes is not a very standard setup and i would like to simplified it, here a network diagram with the example: Basically, the PELeft would advertise its loopback to the router MiddleUP via, eBGP (maybe LU?) .The router in the middle instead of ...
Thank you Harold,i did know that you could import/export between different vrf on the same box, but has your example the 2 prefixes are local on the router.What i would need is that the connectivity is between 2 remote PEs.Something like the VRF on t...
I had the same problem.
The interfaces where not visible in any show interface cmd,
it was enough to enter in configuration mode and no shut them.
Can you please try to enter int conf mode and issue:interface ?it should give you as outout the GIgab...
Reza thank you for the reply,I have already read the docs you attached, what i don't understand yet is:imagine my voice packet as source 10.0.0.1 destination 192.168.0.1for every l2 that the packet go trough if i trust the COS the value stays the sam...
