Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've installed a second PVDM and the hw shows up in sh diag, but I can't use the voice-card 1 or 2 to utilized for transcoding or conferencing. I've attached sh ver and sh diag. The unit is a 2821 with CME 4.3/7.0. Any ideas on this whether it's a...
From release notes and included files, it looks like the 7937 is operational with CME 4.3. However when I go to add the load, it is not available on the list of phones. CME Says it's registered, but it never registers. Anyone able to get this to w...
I've connected an IP security camera that has SIP phone capabilities to our CM 5.1. All the phones are Cisco SCCP phones. The camera is fully registered and can call any extension in our calling space. However when I try to call the camera from th...
Does this apply to all static NAT'ing on this device? Makes it pretty useless for anyone who has a server they need to expose. Can you do a PAT only without a one-to-one? I think this will be the last time I get burned by this Cisco SMB stuff. Al...
I'm running into the same error and have forwarded the error to my ITSP for their review. I am behind an ASA with SIP inspection on. I've attached the text file with the error message. Outbound is fine, inbound does not work.dial-peer voice 1001 v...
load 7937 apps37sccp.1-2-1-0No .bin for the load statement should get that load on there.ephone 9 device-security-mode none description ***** Conference Phone ***** video mac-address 0004.F2E1.0A92 paging-dn 101 codec g711ulaw type 7937 button 1:1...
