Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
With reference to attached document,I want to add LAN on boh sides of the router and want to pass ospf routes via GRE Tunnel and LAN traffic via ipsec tunnel beween ASA.What changes are required at routers and ASAs.Thanks in advance.
Following is the configuration of Switching module in router. interface FastEthernet1/0 switchport access vlan 5 switchport mode trunk ! interface FastEthernet1/1 no switchport ip address 10.1.1.1 255.255.255.0 ! interface FastEthernet1/2 no switchpo...
NM-16ESW modules into 3700 creates an vlan 1 interface.IS this the mangement interface for switching moduleor what is the purpose of assigning ip address to this vlan 1.
In the scenario,main office is connected to the branch office via ipsec vpn.We want to access two systems in our main office from brance office.But can access only one of the two at a time when connection established.can any one tell what is the issu...
Sorry forgot to mention that Both ASA are connected via WAN Link not with the internet,Plz reply as soon as possible.i shall be thankful for an early reply.
Thanks for reply,but can someone provide the detail of simultaneous 25 SSL sessions.Also can someone explain ,There should be 1024 tunnels (plain and encrypted).and 256 tunnels should be encrypted.
Thanks for reply,Following is the configuration of Switching module in router.interface FastEthernet1/0 switchport access vlan 5 switchport mode trunk ! interface FastEthernet1/1 ...
Thanks for reply.detail is that,Site A is using strong swan for Ipsec vpn tunnel to site B having PIXfor VPN tunnel.There are two servers on two different subnets at siteB.Want to access both systems from siteA via ipsec tunnel.But can access only on...
