Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When using a Cisco 2504(25 AP) WLC with 3702 Access points and 3702 sniffers, all the PS-Poll frames get decoded through Omnipeek as malformed with no source address. The WLC firmware is 8.3.111.0. An older 4402 WLC and 1252 AP's as sniffers didn't h...
Can someone tell me what the DB9 to DB9 serial console cable pin-outs are for the Cisco AIR-WLC2006-K9 WLAN controller? I have two of these controllers and I plan to donate them to a good cause along with some AP's but obviously if I can't configure ...
We have seen issues with a Cisco 5500 and 2405 WLAN controller with older and the latest controller firmware(8.x) of not forwarding the first EAP Response frame to the radius server on 802.1x WLAN devices doing full authentications. The first EAP Res...
Thanks for the reply Rasika but I already tried that cable. Checked it out with an Ohm meter, cable was pinned correctly. It worked on a 4402 controller but not the 2006. I did try all kinds of serial settings and usually you get some garbage display...
