Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have an ASA 5510. I have two internal networks: 192.168.1.0/24 is connected directly to the ASA. 192.168.10.0/24 is connected to 192.168.1.0/24 via a Cisco 1811 router. I would like both internal networks to be able to communicate with e...
Hello,I have and ASA 5510 and would like to be able to access the MGMT network including the AIP-SSM module from the internal network. I am a Cisco newbie.Mgmt port: 192.168.22.1AIP SSM Mgmt port: 192.168.22.254Internal network: 192.168.1.0/24I ca...
Hello,On an ASA5510 v8.0(4) is there a way to create a network object group and enter a range of addresses rather than entering them one at a time? For instance I have a group that will need IP address 192.168.1.60 to 192.168.1.75. Do I have to ent...
Hello,I am a Cisco ASA newbie. I am having trouble grasping ACL concepts. We will want all outbound traffic from LAN to WAN blocked; except as we see fit to allow. I understand by default all traffic is allowed to the less secure interface. Do I ...
Hi,We are in the process of upgrading our infrastructure. We are going to be deploying a Cisco VOIP system in our home office for about 110 people. We are going to replace all of our switches. We will be hiring a consultant to aid in the implement...
Brandon,There is very little traffic between the two subnets. The 192.168.10.0 subnet almost never has more than a few PC's connected. It is mostly used for company meetings and occasionally for guest access. I had also been utilizing the 1811's f...
Hello,Thank you very much for the assistance. I can't use the 1811 for the gateway on the 192.168.1.0 network as I do not believe it can't handle all the traffic. I guess my best option is to utlize another interface on the ASA and remove the 1811 ...
Jon,I am viewing the rules in ASDM 6.2. I have attached what the default rules look like in ASDM. That's where I got "implicit permit." But, I think I get it... Once I am done creating the ACL I want to allow out, I create the deny rule?Thank you v...
