Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an applications that will be using roughly 16k-64k IP addresses directly connected to a switch, That is .1/24 will be assigned on the switch(or router) and the full subnet will be used by hosts.These can be broken into groups of 32 class Cs p...
I had thought the default combo was cisco/cisco.
I was unable to validate the before and after of issuing "no username cisco". Even if i went through and issued the command on all my routers, i wouldnt be able to come back and validate if I had don...
OK I think i figured it outafter i loaded more than ~6k arp entries the switch started tanking the cpu on the 3560, unable to fully test on a 6500 though. the only way to get the 12k mac that the datasheet specs(for 3560) is if you use the sdm "vlan"...
mac-address implies layer2 switching, i am doing more than layer2 switching. I am doing locally connected routing.meaningi typically link mac address with the mac-address-table, here i am looking at the arp.
