Hi,This is a fragment from a Cisco doc:"SSL VPN Client (Tunnel Mode)—Downloads a small client to the remote workstation and allows full secure access to resources on an internal corporate network. You can download the SSL VPN Clie...
Hi,I'm trying to replace PIX 506[working ok] with asa 5505. But justafter swaping them some of the vpn links doesn't work. I can't pingsites. Cisco vpn client access doesn't work too. I was following fewcisco manuals but I can't figure out what is mi...
Hi,I was following the below doc to configure basic l2tp access for win XP default vpn network connection:http://cisco.com/en/US/docs/security/asa/asa80/configuration/guide/l2tp_ips.htmll2tp config lines:ip local pool MS-POOL 192.168.22.90-192.168.22...
Hi, Is any one using 1801 with url-server (websense)? I can do it on my PIX 506: url-server (inside) vendor websense host a.b.c.d timeout 30 protocol TCP version 4 Is it supported on 1801? Any issues? Thanks and regards, lesniak81
It looks like my config was ok except many silly mistakes I've made.Every vpn link is up + cisco client is ok :-)))But it took 2 hours to reestablish vpn link between 5505 and PiX501 in one of my locations.Any idea why? [debug was made during problem...
Could you explain why does ["crypto map outside_map 100 ipsec-isakmp dynamic dynmap"] makes the diffrence. What is the impact?regarding access list:access-list inside_nat0_outbound extended permit ip 192.168.1.0 255.255.255.0 192.168.9.0 255.255.255....
Many tanks for your reply.I have sorted most of the issues:1. I was pointing to the wrong radius server.2. pre-shared key for Cisco Client was wrong.3. there is ..."set pfs" command in one site so I have added this to my config- it works!I didn't tou...