Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Assume you have a FTD/ASA HA with combined failover/state link and no IP addresses configured on any interface.
What happens when Failover link turns down?
I think the active/standby roles remain on each device.
But what happens when active device ge...
The question is: how can this can be archived...
Workaround: ISE images does not support Accelerated network, so disable it and then restart ISE, make sure the MAC address of eth1 interface is removed from both show inventory as well as from ise db.
...
I had the same issue on a new 1150. I reverted temporarily to Snort2 and switched back to Snort3. After that sfhassd stayed disabled and the message was gone. Perhaps you can try this if an interruption is acceptable.
