About cdalask

cdalask · 11-25-2009

Recently upgraded our Cisco 4948 with no apparently problems. The switch appears to be opperating fine. However when you enter "show version" it still shows the old IOS. When you enter "show config" or "show running-config" it shows the upgraded v...

cdalask · 11-30-2009

Success! I believe my error was not entering the word bootflash: after boot system flash. Thanks for your support and patience!~c

cdalask · 11-30-2009

I noticed you entered the word bootflash:/ with a slash before the filename. This could be where I'm missing the boat because it doesn't show "bootflash" when I use the auto complete feature. I have been entering #boot system flash cat4500-ipbasek9...

cdalask · 11-30-2009

Jon,When it does attempt to boot at the rommon prompt I can see it attempt several times before I have to type "boot" at >rommon. Below are the commands you requested:ABC-Switch#sh run Building configuration... ...

cdalask · 11-30-2009

Jon,Followed your instructions to the letter. The Catalyst still boots to >rommon. I am forced to enter "boot" at the rommon prompt in order to get the switch to boot from the old IOS. I have the registry at 0x2102 now as well. I can copy an past...

cdalask · 11-30-2009

I'll give it a try. I should also change the registry to 0x2102 before reloading...correct?Thank you

Member Since	‎02-09-2005 10:57 AM
Date Last Visited	‎05-06-2022 12:04 AM
Posts	10

User Statistics

User Activity

Show Version command displays old IOS on Cisco 4948?

Re: Show Version command displays old IOS on Cisco 4948?

Re: Show Version command displays old IOS on Cisco 4948?

Re: Show Version command displays old IOS on Cisco 4948?

Re: Show Version command displays old IOS on Cisco 4948?

Re: Show Version command displays old IOS on Cisco 4948?