Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My site router is connected to 2 remote routers thru Internet. Any ideas how can I set load balancing up if remote sites get their ip addresses from ISP's DHCP server?
Looks like my PIX501 not doing what I told it to do. I want my internal LAN traffic to be NATed and crypted to all remote private LAN, except destination specified in ACL:access-list toJoseph permit ip 10.1.1.0 255.255.255.0 192.168.200.0 255.255.255...
Hi,How can I check whether traffic is going through tunnel? Tunnel is up and running. When I ping remote end private IP, no replies. ICMP is allowed on PIX. See attached config.
Hi,The example is not relevant to my case. Please see attached diagram for my topology. I need load sharing between destination routers B and C when accessing it from A
