Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi:I have configured failover over two servers (Solaris), and this work OK; but when I down the main server, the backup server into in Partner-down and assigned IP address to old clients. The problem is that if I create new clients and Scopes in this...
Hi:I have a CMTS with version 12.2.15-BC2C, a CNR version 6.1.1.2, and several cable modems with various version DOCSIS (Motorola 2.0, Motorola 1.1, Com21 1.0, Scientific Atlanta 2.0).I configure in the CMTS subinterfaces with the command "cable Help...
Hello:I have a problem, the css assigne the servers a the clients by srcip, but It no balance (round robin); it assigne all the same server serv1 and no the server serv2.I adjunt config.CSS11050# sh runn!Generated on 11/25/2004 13:10:16!Active versi...
Hello:I have a CSS 11501 where I need to balance Telnet,I can´t get service up and running.My client need telnet to server connected to a server farm. I adjunt config and Troubleshooting.!*************************** GLOBAL ***************************...
Hi:Acceding of any client, always it connects to the server serv1, it is to say the client "a" is connected and it sends it serv1, client"b" connects itself and also she sends it serv1; is to say to nonbalance to the second client to the other servid...
Gilles.Thank you for all information, it was very good. I probe it and solve the problem, but now need connected two or more CACHE with one CSS, and I don't can make correctly.How redirected the traffic from Internet the CACHE that make the request, ...
With the Catalyst 6500 w/csm module I need two Routers (1-Client and 1-Internet), or is possible other scheme.In the Catalyst not have that configure acl, and static route; or have that configure the same that in the CSS.How configure if I have two o...
I don´t understand if I need to configure WCCP in any of the routers or only configuring WCCP SPOOF-CLIENT-IP ENABLE in the cache is enough.Thank you very much for your help.Guillermo
