Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,So we recently used CBD for the first time to schedule firmware upgrades to our switches. All succeeded except for one C1200 (all are either C1200 or C1300). It gave the following error:Internal error (java.lang.NullPointerException)I can't find...
I have a similar question as this old one: https://community.cisco.com/t5/cisco-business-dashboard/stop-autodiscovery-just-monitor-static-devices-in-inventory/td-p/4568247I don't necessarily need auto-discovery turned off, but I do want it to stop at...
Hi,So we have a bunch of C1200 (and a couple of C1300) series switches that we recently bought and I've configured for our setup, however I've noticed that after doing so, I can no longer console into them unless I have the cable connected to the swi...
It was a scheduled task, so I wasn't actively watching it while it worked (I had already tested against a couple others at an earlier time), and the log I can find doesn't seem to clarify this any. After the failed upgrade, the switch has been in su...
Well, this took forever and a day (), but the last device finally dropped out of the active inventory list and so no longer shows on the dashboard.Thank you for your help, though I still maintain the opinion that the CBD should never have been pulli...
@Mark Fang wrote:Polycom phones and Ubiquiti APs are already blocked by the discovery filter, as indicated by the block icon next to hostname. By default, the inventory is displayed with the "Show Discovery: Enabled" filter, which only lists devices ...
@Mark Fang wrote:Once you disable the "MAC address table discovery" option, these devices should change to offline status after about ten minutes. Once they are offline, you will be able to delete them from the inventory.Ok, thanks. It seems like al...
@Mark Fang wrote:Polycom phones and Ubiquiti APs are already blocked by the discovery filter, as indicated by the block icon next to hostname. By default, the inventory is displayed with the "Show Discovery: Enabled" filter, which only lists devices ...
