Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2651XM which has IOS version 12.3(10), RELEASE SOFTWARE (fc3) and System image file is "flash:c2600-i-mz.123-10.bin. When I try to go to controller T1 0/1 and try channel-group 0 timeslots 1-7 speed 64 , it works fine. But then when I try to...
I have a 2651XM which has IOS version 12.3(10), RELEASE SOFTWARE (fc3) and System image file is "flash:c2600-i-mz.123-10.bin. When I try to go to controller T1 0/1 and try channel-group 0 timeslots 1-7 speed 64 , it works fine. But then when I try to...
I have a PIX 520 running on 5.3.3. I want to monitor CPU utlization. I tried this OID:1.3.6.1.4.1.9.9.109.1.1.1.1.4.1and it did not work. If anyone can give me any tip on how to monitor cpu utlization?
I have 520 PIX running in failover fashion using a Serial cable for failover heartbeat. Primary loses communication with secondary for no obvious reason and it gives a jerk on LAN for connectivity. When I boot primary first and then secondary, I can ...
I have two 520 PIX running in failover mode on 5.3.3 version. I am getting a message on Primary such as "(Secondary) Lost Failover communications with mate on interface X" and then if I do show failover, it says that its doing testing on both interfa...
