Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have following config for Qos.Basically Access-list match the voip/signalling traffic & put that in High queue. I am trying to figure without hight utilization why I am seeing output drops in high queue.7206#sh int s5/1/5:0Serial5/1/5:0 is up, line...
Thanks for all your reply,I found that we have Avaya Definity System with S8700 & found configuration documentation :http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/pbx/interop/notes/410364av.pdfWhat I found that Avaya side is configured for Qsig...
I found this weird but we are using Cisco call manager 5.1 & when I hit next it does display rest of the directory but number on phone screen reset to 1 rather than 32 so if you do not pay attention to name,it can trick you.I hope this help you.
I work in the company where this is standard config. I know that Cisco recommends LLQ instead of PQ. what I am interested here is about the output drops in High queue without overutilzation ? Is there some application using udp port range that match ...
