Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks!!!I hope You are all right.I would like to configure a VC on Cisco Catalyst 6500 series switch and bind it to trunk. I know how to configure a VC, but I do not know how to first: configure a tunnel bewteen two endpoints and second: bind conf...
Hi Everybody!Normally network devices in different VLANs cannot communicate with one another without a router to route traffic between the VLANs. The question is: is it possible to ensure communication between VLANs at Layer 2?Best regards,Agata
Hi Everybody!!!I have noticed that I can log in using almost every configured IP address on the device (here Catalyst 6500).I'm wondreing why? I'm not talking about source address, but the destination one.I have many vlan interfaces configured on the...
Hello Everybody !!!I wanted to delete Gigabit Ethernet subinterface, so I invoked no interface gigabitEthernet 3/26.1 command. I've got the following output from Catalyst 6500 switch: Not all config may be removed and may reappear after reactivating ...
Hi Laurent and Other Folks,I found electronic version of MPLS Configuration on Cisco IOS Software book by Bancy Lobo and Umesh Lakshman. Here is the link: http://mpls-configuration-on-cisco-ios-software.org.ua/1587051990/main.html.Please see the sect...
Hi,On what platform are you running TE tunnels? Bacause I have configured EoMPLS on physical interfaces and I'm not sure if I can configure TE tunnels with primary and backup paths to provide LSP Path Protection.I use Cisco Catalyst 6500 series switc...
Hi Joe,I have already found this document, but with Your post You made me sure that this what I was looking for.So let's clarify that TE Tunnels with primary and backaup paths within are available with Cisco Any Transport over MPLS: Tunnel Selection ...
Hi,Yes Laurent, that is what I mean.I issued the command show mpls traffic-eng tunnels and there is an entry about the tunnel I want to configure between Cisco and the other device. I think that is because RSVP is signalling.But when I issue the comm...
Giuseppe!I understand that PFC is a piece of hardware, but I did not realize that PFC = MUX UNI. I thouht that MUX maybe software feature, but as soon as it is multiplexer it must be a device.I have clarity now. Thank You Guys for being helpul and p...
