agata.czekalska
Level 1
Level 1
Member since ‎10-08-2009
‎08-18-2017

User Statistics

  • 20 Posts
  • 0 Solutions
  • 4 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Discussion Posts
20 Discussion Posts
First Discussion
First Question
10 Discussion Posts
1 Reply
10 Replies
5 Replies

User Activity

Hi Folks!!!I hope You are all right.I would like to configure a VC on Cisco Catalyst 6500 series switch and bind it to trunk. I know how to configure a VC, but I do not know how to first: configure a tunnel bewteen two endpoints and second: bind conf...
Hi Everybody!Normally network devices in different VLANs cannot communicate with one another without a router to route traffic between the VLANs. The question is: is it possible to ensure communication between VLANs at Layer 2?Best regards,Agata
Hi Everybody!I have question: when a VC is configured on an interface, does routing protocols are disabled on this interface?Thank You,Agata
Hi Everybody!!!I have noticed that I can log in using almost every configured IP address on the device (here Catalyst 6500).I'm wondreing why? I'm not talking about source address, but the destination one.I have many vlan interfaces configured on the...
Hello Everybody !!!I wanted to delete Gigabit Ethernet subinterface, so I invoked no interface gigabitEthernet 3/26.1 command. I've got the following output from Catalyst 6500 switch: Not all config may be removed and may reappear after reactivating ...
Community Statistics
Member Since ‎10-08-2009 11:40 PM
Date Last Visited ‎08-18-2017 03:55 AM
Posts 20
Helpful Votes Given To