Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, what I have is a asa box sending the syslogs over the vpn, that part works, have the vpn up , management interface set to inside and all is well, however when I use a static nat to change the network behind the asa to a new IP scheme it no longer...
Hi, I have a site with two 1250s set up, they have the same ssid and when we set them up I was able to roam no problems no packet loss everything was great. Not seems in the past couple of weeks they have been having frequent drops on clients , there...
We just set up an 1200 AP with WPA and all was well for that day, today of the 3 devices that access it only 2 will connect now. I get Authentication failed on the other. I have re-entered the WPA key a billion times now, I tried turning on some debu...
Ha! this is true but then it would just work and all would be well I hope to have a test asa on they way, Sometimes it can be a bad idea testing stuff on a device 200 miles away. I think I can add the second address but since I have never tried tha...
well no, basically all the remote sites are asa units and my end is the linux box, so far I have pretty much been able to do whatever I need but just have to test more sometimes to get it working, I can just tell most of the time traffic does not go ...
Well thanks for all the help but I am not going to be able to use this method, I am not going to be able to connect a cable at all the sites, I don't know If I can just wire an RJ-45 as a loopback plug maybe but still not a good method. Also when I r...
Alright I guess my next problem is when I assign the new interface to an ethernet port I don't have any that the link is up on or need to be really, I keep getting that my new interface in shutdown, I issued the no shutdown command but I still get th...
Let me see if I have this right, most of my asa units are the base units, so I can make a new interface , restrict flow to say inside then add a nat exempt for it and add it to the cryptomap to send it over, then add the command like you specified ...
