Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Ivan,Paolo is right. We don't need the destination-pattern command if you are looking to control the analog endpoints via CME. The destination-pattern is for providing an extension number to the analog stations.However you may use the destination-...
Hi Ivan,Can you try this config to test out:Remove all the commands under the voice-port:voice-port 0/1/0!voice-port 0/1/1Dial-peer association should look like this (remove the extra config)dial-peer voice 500 potsdestination-p 1001port 0/1/0!dial-p...
Hmm.. Interesting problem.I was thinking about the timeout issue. What is the latency between this router and the Publisher (ping response)? Can you try configuring MVA on a router with less than 50ms of latency towards the Publisher and let us know...
Assuming that your configuration is correct, I would say that that it might be a caching issue on the router. A reload of the router (or a cold boot i.e., power off/on) should clear out any corrupted cached values. Dont forget to save your configura...
