Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About chris.monk
Stats
Member since
07-11-2010
18
Posts
5
Helpful
1
Solution
08-29-2012
Correct, you can do that with the statics in place still, checking the
ospf database for the new def...
08-29-2012
It doesn't look like you are receiving the static default route from
your remote site. Are you filte...
08-29-2012
Post the output of "show IP ospf database" that will tell us if you are
getting a default route from...
08-28-2012
Andrew,If you are redistributing the static default route from your
remote office into ospf, you do ...
08-27-2012
Could you check for drops on the uplink between the stack and your edge
at both sites? Also, could y...
08-27-2012
I apologize, what software/server are you using to send the data to your
remote site? Is this server...
08-27-2012
What platform is transitting this data? Is it connected directly to this
switch?Sent from Cisco Tech...
08-25-2012
I disregarded the most basic questions...Was what you were pinging from
(to the servers) also apart ...
08-24-2012
Well I don't see anything wrong with your setup, unless those static
routes in your local server roo...
08-24-2012
But if he is ECMPing, as he is, he wouldn't have totolly lost connection
to the site as he described...
08-24-2012
Could you post the other side's routing table as well?Also post show ip
protocol and show ip ospf ne...
08-24-2012
You have specified the cost of static routes, not OSPF routes. OSPF has
nothing to do with those rou...
Public Statistics
| Date Registered | 07-11-2010 06:12 PM |
| Date Last Visited | 09-07-2018 12:03 AM |
| Total Messages Posted | 18 |
| Total Helpful Votes Received | 5 |
