Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have 2 9124AXE-B I am trying to set up and get mesh working on. I am using a 9800 on version 17.12.5. I cannot get the mesh tab to show up or even get the ap in bridge mode, I have the mac in the Device Authentication mac address list like s...
I have that mac in there which is the ethernet and is it not working. I followed what those instructions you sent said for the MAC AP authorization List - Local and it is not working.
@Mark Elsen I am seeing this, AGE-5-AP_JOIN_DISJOIN: Chassis 1 R0/3: wncd: AP Event: AP Name: APC828.E53A.E6CC Mac: 18f9.3519.2be0Am i supposed to be putting in the base radio mac instead of the ethernet mac?
@Mark Elsen I have the ISE servers in here for RADIUS but have not done anything with it for ap macs, as far as I knew I thought it was the device auth for all of that was done on the wlc itself. Is there a different way I should be setting this up ...
