Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
Do you know that there is a command or tricky way to check whether an access-list (e.g access-list 1) is used by any route-map, interface, etc in the configuration?
I have Catalyst 6509s with IOS version 12.2(18)SXF7
Thank you in advance.
Hi All,Earlier we found that we can change the TCP buffer size (rx, tx) also for SSL and compressed HTTP connections in the CSS configuration, but not for pure HTTP connections. (relevant discussion: https://supportforums.cisco.com/message/3715362#37...
Hi All,Do you know the relevant commands and syntax for the following ACE commands for CSS environment? I need to fine-tune some old CSSs and I know the proper ACE configuration steps, but not for the CSS:- persistence-rebalance enabled- header-maxpa...
Hi Alexey,
Yeah, I was really interested in whether a built-in command exists for this or not. But if not, then I need to stay using the pipe.
Thank you.
Peter
Hi Lajan, From your PBR configuration it seems that the traffic will only be directed toward the next-hop address 192.168.1.4, if the traffic is sourced by the IP address of 192.168.1.91.Check the sections of "PBR Route-Map Processing Logic" and "PBR...
Hi Carlos, If you used the switch as an L2 switch you probably had a default-gateway configuration as well to manage the switch from a different IP subnet. When you applied the "ip routing" command the default gateway setting was gone, so now you don...
Hi, as you can see from the output of "show vpc" the Type-2 consistency check not performed. It is probably due to you have not configured any type-2 consistency check related features on your devices that would triggers the type-2 inconsistency chec...
Hello Salman,Like VTP version 1 and VTP version 2, VTP version 3 uses the concept of device roles. As for the Server role VTP3 expands and enhances the concept of the server role. The default server role will be the secondary server subtype.It produc...
