Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys...I forgot the password for AIP-SSM-10 module and am trying to break it by recover. It runs 5.x and hence have to do a recovery. upon recovery procedure the image copies to the system from tftp server and throws the below error message...S...
Hi,is there anyway that we can enable this inspection in Firewall Service module? the escenario is we need to use an external company's VPN software inside our org and its not working. The traffic needs to cross FWSm to reach internet. so thought of ...
Hi,below is the message i get from FWSM. The IP's always change but what i see is its always any of the Windows DC's located across globe.2007-10-26 00:42:18 Local4.Critical <FWSM IP> Oct 26 2007 00:42:51: %FWSM-2-106007: Deny inbound UDP from <IP/53...
Hi,We have a FWSM module in 6513 core switch which acts as the gateway between Vlan's.We have an exhange server in one VLAN and now we face a connectivity problem to this server on port 25 from other VLAN's. The port is open and no restrictions are t...
I get the following error message while trying to establish a VPN tunnel between ASA and a Fortigate device. Phase 1 is completed. Get the following messages.* P2 struct &0x18053890, mess id 0xdb47a032* Group = Received non-routine Notify message: In...
Hi,As long as your device is blocking these port scanning/reconnaisance attempts, it means its working as it should.The first log message is how the device responds or protects for spoofing attempts using Unicast RPF (Reverse Path Forwarding)This wil...
i assume the access-list outside_in is applied on the outside interface on inwards direction. And you have a server which is reachable from internet on port 80.If you do not want to permit port 80 access apart from Tac add a deny entry towards this p...
HI,COnnect to the device via ASDM. enable ASDM logging to debug. try to add the client (or connect to DC in dmz from outside) and check whether the device drops any packets. allow those ports as well.Else try allowing ip any for that particular DMZ D...
