Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 5520 with a current span session configured. My question is, can I create a new session, using the same source ports, but a different destination port? I need to make sure this won't disrupt traffic spanning on the initial session.Session 3-...
I have two monitor sessions in our 6500, however, I believe only one is active for our content filtering appliance. From the configs below, I'm assuming the first port is the actual port in use for monitoring, while the second isn't in use. Can someo...
I have several vlans that were created as part of a failed NAC implemementation that I'd like to delete. However, I wanted to confirm they weren't in use somewhere? I'm assuming as long as there are no switchports configured in those particular vlans...
I need to clean up some old routes entered from a previous project and need to confirm there isn't any traffic routing across these ip routes. Can someone tell me how to confirm they are not actively being used? ip route 10.x.2.0 255.255.255.0 10.x.1...
I'd like to better understand the Cisco VPN configuration and troubleshooting issues as needed. Are there any books anyone could recommend that will help me 1.) understand how VPN works, such as the different phases, etc, 2.) what to look for in trou...
Something odd I'm seeing, when I look at this vlan, I see all these ports listed, however, some are regular switchport access ports, on specific vlans, not trunk ports. Is this what I should be seeing? Also, when I use the second command, you can see...
Hi Reza, thank you for the response. This was for some old NAC servers that we powered down a week or so ago, so I'm removing the routes that were supposed to point traffic to them. The original vlanx11 is still active, however, there are no ports as...
Is a newer version of the CCNP Security book you're recommending?http://www.amazon.com/Security-642-648-Official-Edition-Guides/dp/1587204479/ref=tmm_hrd_title_0#selectedObb=rbb_bb_triggerThanks, Tony
I don't believe the switch is set up for 802.1x, but how can I confirm? This user is also now on WIndows 7, if this makes any difference? I wouldn't think it would, however, when we were checking her NIC settings, it kept asking for an adminstrator p...
