Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI am getting a strange error message on a ASR1004 and I am not able to find someone else who has had the same issue or any reference to a bug that might be causing the problem. The IOS version is : Cisco IOS Software, IOS-XE Software (X86_64_LIN...
I am trying to setup udld running between a 2811 router and 3524 switch without much success. Between the two devices is a fibre circuit with media convertor on either side. The router and switch are connected via the media convertors by copper. Ther...
HelloI am trying to find a mechanisim that will allow me to poison a certain BGP route eg: add 200 to its AD, via the status of a particular interface. If my fa0/0 interface goes down, I want a trigger that will influence routing decisions within BGP...
Thanks for that, however it does look like it needs replacing as I get this in the log when running that command: Feb 20 2015 11:17:32.837 GMT: %IOSXE-5-PLATFORM: R0/0: kernel: sd 0:0:0:0: [sda] READ CAPACITY failedFeb 20 2015 11:17:32.837 GMT: %IOSX...
No, nothing was registered in the log when it went off-line. The option to 'show harddisk' has disappeared but is still present in the secondary router with the working disk.It just appears to have shut it down completely and removed any option for m...
I did and it produced an error message and has taken the hard-drive offline. Unfortunately the message itself has spooled out and cannot be viewed again. The option to fsck the hard-drive is no longer an option.
Thanks for the response. Is that something that can be tried while the router is operational? Will it interfere with the router and stop it forwarding?
