Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I ask a lot of questions on here....Was at the same site as my other question about the trunk ports. Their environment is three separate networks. Internal is a 3750 switch stack. DMZ1 is a single 3750, and DMZ2 is a single 3750. None of these ar...
We've had some real issues at this site getting the 1Kv up. We were on the phone with TAC for hours yesterday with other issues (one turning out to be a bug)... For the most part everything is going well today, except one thing. When I roll a serv...
For future reference (and in the lab today) what is the process to create a Service Console via the ESX CLI on a system only connected to a 1Kv dvSwitch?
Had someone that cleared the configuration on their VSM the other day without saving it first (was doing an initial configuration). Basically, somehow a new VSM that was brought up to be secondary became primary and replicated a blank configuration ...
Simple cluster....8 hosts total. Working on two right now for the initial configuration. Deployed the first VSM..connected the three interfaces to port-groups on a vSwitch. Rolled the first two hosts in to the dvSwitch..modules come up fine. Crea...
Yes..the 3750 stack is configured for Layer 3. It's actually their "core" switch stack.Dynamic Arp Inspection is left at default:3rd_Core#show ip arp inspection Source Mac Validation : DisabledDestination Mac Validation : DisabledIP Address Val...
I'll check when I get back onsite. The ports on these servers were in access-port mode on the switch before rolling them to the dvSwitch. It appeared..in my very limited testing...that if I reconfigured them for proper trunking BEFORE moving them t...
And after reload (and I added a third NIC before the reload):Eth6/1 3000 eth trunk up none 1000(D) 10Eth6/5 500 eth trunk up none 1000(D) 12Eth6/9 501 eth trunk ...
Thank you Robert. That's the point we got to as well and had the same problem. We couldn't figure out how to get it in the right uplink. Let me know what you find.
Yep! That was it. I was just coming back to say that...I found it a minute ago. That was it. I guess I got it right (accidentally) on the second test.Perfect. Thank you both very much for your help. Customer will be very pleased.
