The fact that you're sub-interfacing and have an address on the physical interface itself doesn't seem right to me.....I believe, and I could be wrong, that you shouldn't have an ip address on fa0/0 if you're subinterfacing... If you were to move th...
Ip accounting is one way to go about it.... if you would like more detailed info though I would suggest using netflow....Turn cef on within the router... cisco# config tcisco(config)# ip cefthen go into the interface in question and turn on ip route...
Those settings look correct... What type of cable are you using to connect to the console port ? You can't use an ordinary RJ45 straight through. You need to use a roll over cable.The specs for a roll over cable are below hope this helps...Your ro...
You can change the AD using the distance command once in routing config mode....cisco#cisco# config tcisco(config) router eigrp xxxcisco (config-router)#distance eigrp xxx xxxin your case to make them the same you would use cisco (config-router)#dist...
