Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i am looking for a basic configuration for a teleworker set up, with the remote office using a 877w and a UC520 at the main office. First is there a simple config to get the 877w functional should i use CCA? If i use CCA can i set it up to use a vpn ...
i am trying to set up a multi-site configuration on our UC500 over an mpls network. Our main office has the UC500 the offsite location will have a catalyst 3560. How do i set up the ip phones attached to the 3560 in the offsite location to be able to...
Hello everyone i am very new to cisco and have been testing out the capabilities of our UC520. i am having trouble finding documentation on how to configure an IP phone for a teleworker who will be bringing a phone home and connecting it to their dsl...
i think mwi works with dial peers, and dn's you should check to see if you have dial-peers and dn's set up for MWI for exampleephone-dn 223 number A801.... no-reg primary mwi off!!ephone-dn 224 number A800.... no-reg primary mwi ondial-peer voice 6...
yes, this is a private mpls network, and yes the 3560 is L3.Ok, so at my offsite location i will have the voice subnet of 10.1.2.0.the mpls router at both of my locations will have routes for 10.1.1.0, 192.168.10.0, 10.1.2.0, and whatever internet/da...
