Quick comment:There is a minimum requirement for the ISSU of the NX-OS (I think it's two supervisor modules and two controller cards.) However, since you will likely need to update the EPLD, it will be disruptive because each module is reloaded one a...

Fix for F0853> system support regenerate-security-keyring default Fix for F0855> connect fxosFW# show fault**should show something like:F0853 CLEARED...F0855 MAJOR...FW# sysopt sam 1001 onWARNING: FXOS configuration changes are experimental and are N...

I found this to be a solution to:  Code - F0853; Description - default Keyring's certificate is invalid, reason: expiredLogin to the firewall CLI and enter the following command:> system support regenerate-security-keyring default  

While the BUG was in the system, I was able to console into the device and pull the running config. Be careful because a "write" command afterwards locked me out of the console. A restart did fix the BUG on our Cisco IE4010. The startup config was ou...

This might help you figure out where to look (Page 29/37)http://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/codec-c-series/tc6/troubleshooting_guide/tc_troubleshooting_guide_tc60.pdfSUMMARY:Login the Web GUI as "admin" to the unit.Left co...