Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I did a write erase in a new ASA firewall, and now I cannot configure the interface settings like nameif, ip address.Is there a way to roll back to the default configuration.
Thanks for help.I'm asking all those question because I would like to have the Inside, DMZ and Campus Network in the same switch stack.How can I isolate the DMZ from the others subnets?Thanks.
Thanks for your help.Another question.How do I configure diffent interfaces in the same bridge-group ? and How do can be controlled the traffic among the Vlans when and SVIs interfaces ?
I have an old 4908 switch. Each physical interface has 3 sub-interfaces like:interface GigabitEthernet2.10 description data 10 encapsulation dot1Q 10 no ip directed-broadcast bridge-group 10!interface GigabitEthernet2.11 description voice 11 encapsul...
I'm planning to use multiple T1's for my perimeter router. I also have a PIX Firewall that I'm using for the VPN with the central office it is behind the perimeter router. My question is the tunnel will work with any active connection?Thanks.
