Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have the following situation: server on inside with 192.168.1.1 address outside nat address x.x.x.1this is currently working correctly with static natwe require to have a policy nat where we can nat outside address x.x.x.1 to a second server 192...
Hi,I currently have a single router with 4 isdn bri interfaces. This is used to dial out and accept connections from 5 different external clients, we have no control over the remote routers and we cannot run any routing protocols over the dialup link...
Hi,thanks fot he answer, you've understood exactly what I need with just a slight variation:access-list policy extended permit ip host x.x.x.x 192.168.1.1 --> x.x.x.x will be able to access server at 192.168.1.1 using 160.1.1.2access-list policy ex...
the hsrp and tracking will work ok but will cater for calls which orinate from my central office towards the remote sites, ie all outgoing calls will be routed via the primary router1 and in case of failure will then failover to the secondary router2...
I have an issue with trunking 802.1q between 2 switches (2950 & 6509) over a providers Ethernet infrastructure as mentioned above. My provider gives me a 10MB ethernet link which we are using as a backup link, we have another 100MB link with the sam...
