Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have been unboxing Cisco ASA 5512-X and I am already configure :
Enable telnet access from inside.Configure aaa authentication telnet console LOCAL.username and password for User Local.
When I am telnet the device and input username passwo...
Hi Experts,
I am using Cisco ASA 5515-x.
Firmware 9.4.2
ASDM 7.5.2
I have some questions :
How I need to show vpn-Anyconnect session history ?
And why when I want to show connection status from Anyconnect client using filter on ASDM, the process al...
Hi All
I have a problem. I already setting up VPN Anyconnect on Cisco ASA 5512.
But when user success establish connection and user connected to internal network and internet. Then no long after that, network internal getting down (all the users inte...
Hi All,
I can PING my core switch from local host, but I can not telnet the Core Switch. This is my line vty configuration :
line vty 0 4 exec-timeout 0 0 logging synchronous login local transport input allline vty 5 15 exec-timeout 0 0 logging synch...
Hi All,
I want to setup port forwarding in Cisco ASA (5512-x/ASDM 7.4).
The scenario : Outside interface directly connected to Internet, Inside interface directly connected to Web server. NAT and ACL already setup but I want to telnet web server usin...
Hi Karsten,
If I mistyped something, should I couldn't login to ASDM using the username/password.You're right the security device always use SSH for the access, but this is requested from my customer. Their need to open Telnet and SSH. If I could lo...
Hi David
This the solutions that I done for this case :
1. no nat (inside,outside) source static any any
2. no nat (inside,outside) source static Net-Local interface
Because it affects arp cache
Regards,
Khoirul
