Once. I used this article:http://www.cisco.com/en/US/tech/tk39/tk356/technologies_configuration_example09186a0080174992.shtmlPay special attention to the minimum IOS requirements. If you need more than that, I am guessing you will need to open a call...
As a start, you don't want to have a hub link as full duplex unless you are ABSOLUTELY sure the hub supports it. Even if they say they do, hubs are notorious for barfing on full duplex. The rest of the question I don't quite understand. Are you tryin...
If I understand your problem correctly, that is you want to runa DMZ directly out of the router, it is certainly possible. Just for curiosity's sake, do you not run a firewall? This would be a better place to do NAT and you could then set up a DMZ in...
The easiest way is to use a firewall with NAT capabilities between your network and the router. That poor old MGS doesn't have much left for NAT anyway.... I would recommend the PIX 501 or a SonicWall
