Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I am creating a test bed using IOS-XE Wireless controller C9800-L and C9120. I want to provide PoE to C9120 using port TwoGigabitEthernet0/0/0 of C9800-L but unable to find any documentation to enable PoE on C9800-L. I remember commands like "...
Hi All,
I am facing a problem in NAT. We have done below NAT.
nat (IPLC-IN,OfficeNet-OUT) source static obj-10.1.146.67 obj-59.160.46.182
object network obj-59.160.46.182 host 59.160.46.182
object network obj-10.1.146.67 host 10.1.146.67
but it is n...
Hi James,
For your requirement, Please find below answers:
1. is this possible with my current hardware? Can i simply configure VLANS on the switches and use one port in each of the VLAN ranges for the uplink to the router?
Yes, you can do that. As y...
Hi Opine,
I am sorry but still I am not able to understand why you are not able to configure storm-control. We can configure storm control on portchannel as well.
Thanks
Thanks for your reply. As your concern is if any L2 issue will happen then it may impact your whole network. Let's say loop is created which seems to be major drawback in L2 path. Anyhow when it happens it hits CPU and impacts Routing as well.
Still...
Firewall should be used for traffic filtering but as firewall is not present in this scenario. So, IP Access-list is the only option to block traffic.
But if you have some specific websites that you need to block, then you can route those websites to...
