Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning
I just received new router cisco 4331 and I setup with one SM-X1T3 / E3 card and one NIM-2FXS / 4FXO. After the Router finish load I try to activate (enable) T3 card using this command: RT (config) # card type t3 1 0The Router mark ^ca...
Good morning I'm start working in Network Admin, but I need a little re-fresh above the code y remember the most important but no all. Where I can found all the command that I need to setup form the begining a router and swicth.
Thank,
Good Morning I still working with my new Router and T3 card
And I find this message
%spa-3-msg_parse_failure: SIP1: iomd: failed to parse incoming message from sm-x-1t3/e3++
Good morning
I try the command. I change the card and the router and still with the same problem, but if I install T1 card the router accept the command. I upload a photo.
