Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloMy quiestion is, does Catalyst 5509 supports ATM modules. It is quote unkown from the docs. It's written "Catalyst 5500 supports modules from Cisco lighstream 1010" but down it's written "Catalyst 5500 is 13 modules chasis" Does this means that ...
HelloI have tried to connect two devices: SMC2655W v2 and the Cisco AiroNet AP352. The Cisco device is set to non-root client with 12.03T VxWorks Software. This does not seems to work. When the client is the SMC device it connects to the AiroNet AP b...
I think that ISIS is not an issue here, because you can connect the two spoke sites together using L1/L2 link in ISIS and advertiese L2 routes with large metric, so the link between spokes is not used for L2 traffic, while your link to the hub is up....
if you inspect low volume traffic, outgoing in your case, there is no problem.I've seen problems on low-end with NBAR only when large volume traffic is inspected and redirected or policed for example.
Hithanks for the answerTwo routing protocols on the PE's customer carrier. Because these routers mostly run only OSPF if the customer carrier does not provide MPLS VPNs. If the MP-BGP is used this PEs must support BGP to the carrier VRFs and OSPF for...
By the way, what is the preffered method for transporting lables from the customer carrierLDP or MP-BGP?LDP has the advantage that customer carrier must not maintain two routing protocols, as he probably runs OSPF at his PEs and not BGP. If MP-BGP is...
