Hi, All I have a question that I hope someone has done before. I recently installed a new WCS as our existing one is full at 3500. Does anyone know how to migrate the lightweight Ap templates from one WCS to another? Kind Regards, Carl
Hi, I've multiple Wism's in 6504 chassis and several 4400 wlc controllers all on ver 4.2.61.0 all in the same mobility group.ten in total. Recently we have had to create multiple mobility groups. I've applied access point templates to specify which c...
Hi, PeteHappy New YearThanks for the post.. Navigator is not an options as would require enterprise lic which is too expensive to implement also been advise you should only deploy this when you have in the reagion of 12-15 plus WCS's. Was told when w...
Hi, PeteThanks for the post. Yeah my current WCS support 3500 Ap's and i'm intoducing a new WCS to share the load and for resilience. On my current WCS I have about a dozen templates and was wondering if anyone knew of a way of putting them into the ...
Hi, ThereI have an issue that I hope you can help with. Wism controller with code 6.0.196.0 with 136 remote cisco 1242 Ap's connected. As of late I'm having to reset the Ap's to restore connectivity. When the remote site rings in I can see clients A...
