Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I did "NETCONF/YANG on Nexus" labs and noticed that changes do not get saved to startup-config. NETCONF capabilities of NXOS sandbox do not include ":startup", so <copy-config> operation can not copy running-config to startup-config. What is the othe...
You might be having spanning-tree loop. Make sure that you have STP enabled on the switch. You can also disable either PO3 or PO15. It could also be that you have 2 servers running redundant service which flaps between 2 hosts frequently. Based on MA...
You need to order additional DIMM module, cisco part number MEM2801-128D= and put it into the routerhttp://cisco.com/en/US/docs/routers/access/2800/hardware/installation/guide/10_hw.html#wp1026137
When connected to a hub, some packet loss is expected due to collisions. Switching to full duplex can only worsen the packet loss. It could be that application in Malaysia is protected by firewall which does not allow you to access it. You can run tr...
