About blarochelle

blarochelle · 01-28-2009

IPM 4.1 stopped workingOn our LMS 3.1 server I noticed that the IPMProcess was listed as "down" on the System tab. Checking the IPM tab displays "Error in communicating with IPMProcess or IpmDbEngine. It may be down or not yet up. Please make sure ...

blarochelle · 11-12-2008

In our previous version 2.6, two devices that were connected to a non-Cisco switch would show up on a thick black backbone line, because CDP info was being forwarded through. Now in 3.1, they show up under the Unconnected Devices view. Their CDP ne...

blarochelle · 11-12-2009

I installed CM 5.1.4 and it now looks just like it used to. Thanks!

blarochelle · 11-11-2009

This started working again when the wrong version of HPSIMs was removed and replaced with the correct client version. *Nevermind*

blarochelle · 03-16-2009

I had the same issue with a Aironet 1210 AP and I'm running RME 4.2. I bumped the SNMP timeout from 2 to 10 seconds as well, and the inventory ran successfully.

blarochelle · 01-28-2009

Here is the IPMOGSServer.log file that wouldn't fit in the original post because of the 3 attachment restriction.

blarochelle · 11-13-2008

Ok, thanks for the quick follow ups and thorough answers!

Member Since	‎04-24-2008 09:10 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	10

User Statistics

User Activity

IPM 4.1 stopped working, IPMProcess service won't start.

LMS 3.1 Network Topology layer 2 view behaving different then LMS 2.6

Re: LMS 3.1 Network Topology layer 2 view behaving different the

Re: IPM 4.1 stopped working, IPMProcess service won't start.

Re: Inventory Collection Issue

Re: IPM 4.1 stopped working, IPMProcess service won't start.

Re: LMS 3.1 Network Topology layer 2 view behaving different the