We are looking for any advice on a decent toolset for a window mobile device. Preferrably one that would allow us to telnet/ssh on top of the normal ping, etc... anyone have any suggestions?
I am trying to set up multicasting using sparse-mode with Auto-RP. We basically have a 355012G or equivalent at each of our sites. Our WAN connection comes in on gi0/1 and then we use VLAN Interfaces to seperate subnets after that. I set up sparse-mo...
What port channel id does the controller use or how can I find out? I created the port-channel to the controller and enabled lag mode but the interfaces are not coming up. Any help would be appreciated. Thank you!
I have a menu system set up on a terminal server (3660 Router) and everything seems to be ok except one little annoyance. We use AAA to authenticate and authorize the connections in to our router (for admin and for menu use). Once a user gets to the ...
I was just curious to know if I need to enter both the global command "ipv6 unicast-routing" and the interface command "ipv6 enable" to enable routing on a router? I am just trying to figure out what the difference is with the two commands and if/whe...
I tried using the "G0/1" on the mroute statemet before submitting this post but it said I couldn't do that...Next hop IP address required for multi-access media.
This may be the issue. I will have to check it out when I get in tomorrow. Is it just the GLC-T? If I use the Fiber version of the SFP (I think GLC-MM-SX) then that should be fine?
Can I even install 12.1 on a 3500XL? I thought the versions stopped after the 12.0 versions for the 3500XL. I looked on cisco and under 12.1 the is no option for "3500XL".
But I wouldn't need it since vlan3 is getting it's dhcp from that edge router. It sees the broadcast. the ip helper is there because the server that handles dhcp for those vlan's is in another network. My problem is the phone traffic isnot getting ta...