Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have two 3750G switch stacked using the stackwise cables. On the member switch, when I change a switchport from VLAN 1 to any other VLAN, it drops the switch port from spanning tree and the light goes amber. When I put it back to VLAN 1...
I agree with Peter too. Here's the output:STACK1#sh sw detailSwitch/Stack Mac Address : e804.6245.3e00 H/W CurrentSwitch# Role Mac Address Priority Version State------------------------------------...
I just just checked another stack - session 2 IS getting the VLAN info and the VTP info - unlike the problem stack. The issue is, we've replaced that whole stack hardware - switches, cables, SFP modules - and it did the same thing!! Confused, or t...
As far as I know it has. Does the interconnection of the stackwise cable matter? At the moment there are connected like this:MASTER 1 2 \ / X / \MEMBER 1 2STACK1#sh sw stack-rin...
If you type "session 2" from a stack enable prompt, so can actually see what the member switch 2 is doing (in this case I only HAVE one member). This is available as each switch in the stack runs its own spanning tree instance per VLAN, although the...
thanks for your reply - i didn't check but the VLAN is there when I type "show vlan b" from the main prompt, but when I go to the member switch session (session 2) it is not! Why are they not syncing up?thanks for pointing me in a very solid directi...
