Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know if there is a easy way to convert the install from Windows OS to a RedHat server?Will the WCS backup ran on the Windows OS be able to restore on the RedHat install?Thanks.
Can the ACE be setup with only one interface configured and not having to place the servers on another interface?Some of the "lesser" loadbalancers have a "Direct Server Return" mode. Where requests come in one interface and out the same interface to...
Running PIX 6.3(5)Goal is to translate a outside external src IP 12.12.12.10 to a internal ip 172.16.1.200 on the inside of the PIX.Tried to use static (outside,inside) 172.16.1.200 12.12.12.10 without any luck get 305005: No translation group found ...
Turning up some new LD outbound only T-1's. A call that uses these T-1's is not sending CID information. We have the external number mask setup on the DN, which worked fine before with the PRI. I have seen some comments regarding caller-id with certa...
I have WCS with location installed. From the Cisco documentation the WCS with location is suppose to provide a small set of location/mapping functions. Adding the location appliance will give you historical data.When trying to view clients on the flo...
Did you ever get this to work?I would like to setup a SIP trunk to a provider without having to use a voice gateway. I dont see anywhere to place the UID/password required for the SIP trunk within CM. Running 6.1
I actually get information from debug voip dialpeer but the called # and calling # are blank.debug vpm signal doesnt show me any CID information. I want to see if the gateway is even seeing the CID information and not passing it out the T-1. I dont t...
