Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We apply QOS via Radius but lately we've got reports of customers not being restricted to their bandwidth we set especially on the download side. When i check the customers policy-map it looks like their not getting matched on the outbound. I'm not s...
Is their a way via YANG to lookup a subscriber session for the BNG? basically the YANG equivalent of sh subs session filter username XXXXXX detail location 0/rsp0/CPU0sh subs sess filter mac-address XXXX.XXXX.XXXX detail location 0/rsp0/CPU0
I'm prepping our ASR9001-S for integration as BNG, we have a M-LAG based core for aggregation and routing... so basicallyy we have... AGG1 AGG2 BNG1 BNG2COR1 COR2 The idea was to connect each BNG 1x10G to each of the agg's for subscribers (e...
Ok so i have ipv4 IPOE subs working more or less they get the IP from dhcp get access, but not that i'm trying to implement QOS i'm hitting an issue i am using a ASR9001 for our BNG.
i attempted to use a COA to set a speed
coa_w32.exe -n 172.16.0.1...
Ok we just got our ASR9k1 and we are trying to get to the most stable version but i dont know if its just me but its been frustrating so far.
First can't decide between which image to use, tried looking at the features comparer and basically still ...
On the ASR9001, i'm trying to figure out how to get information on customer usage patterns on BNG pppoe, i know the manual says netflow on subscriber interfaces isn't supported but perhaps enabling it on our ports to the upstream (internet) would do ...
Thanks for the suggestion, Sounds possible, I'll give it a try but that doesn't really explain why it only happens on the ASR and didn't happen on previous BNG's we had.
I have an odd issue, we've got our ASR9001-S working its handling clients great in a GeoRed config.
But we've noticed when customers connect it's taking noticeably longer than our old PPPoE Concentrators... After the verifying username and password...
Well it's setup as HA, so MC-LAG to a remote MC-LAG pair of switches (1 port per switch, per asr, so 4 ports total)
It's in the default load balancing mode...
Load balancing:Link order signaling: Not configuredHash type: DefaultTe0/0/2/0 Local Acti...
