Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ASA5510 with 8.3 and a Cisco PIX525 (retiring). The ASA was for VPN traffic only while the PIX was for all other Internet traffic. I'm trying to move all the traffic to the ASA5510 so I used the PIX to ASA migration tool. I migrated the PIX...
I need some help with a setup for email.SetupI have a PIX525 and an ASA5510VPN and an internal 2950 router. The PIX does firewalling and the ASA does VPN. Currently all outbound Internet traffic goes through the PIX via the router with this command:i...
I currently have a PIX525 and we just purchased a ASA 5510 to do VPN. What I want to do is leave the PIX in place as firewall and use the ASA device strictly for VPN. Current traffic flows like:Internet router - 146.145.xxx.xxxPIX Outside - 146.145.x...
What do I need to configure to allow my remote (WAN)connections access to my AS400?Here's a quick overview of my network:remote sites - 172.16.xxx.0/24LAN - 10.1.0.0/16LAN Router - 10.1.1.254/16AS400 - 10.1.50.1/16Here's the scenerio:From 172.16.xxx....
I need help configuring my PIX to allow SNMP to the DMZ from my management subnet.the management subnet is 192.168.45.0/24(inside firewall), the lan subnet 10.1.40.0/24 (inside) and the DMZ is 172.17.6.0/24I need to have my management station alert m...
That's currently how it's setup. However my VPN users need access to the network, the inside address (10.1.1.4) of the VPN is routed the this router (10.1.1.254) and all of these devices are on the same subnet. When send a message from 10.1.1.5, whic...
I setup PBR but it killed my routes to my WAN sites. I'm wondering if it had anything to do with putting the ACL on ethernet interface of the LAN. Once I use an ACL doesn't it by default block all other traffic not specified by the ACL(s)?
Tell me about it, anyway I can get into monitor mode and tftp, however when I try copy pix635.bin I get the same thing. It goes through the install, reboots and then tells me there is no bootable image. Now I get the following error An internal asser...
