Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,I have couple of questions regarding SSH and telnet clients running on my WAAS boxes (ver 5.3.3). I noticed that it is possible to initiate SSH or telnet session from WAAS box even if telnet and SSH services are off ("no sshd enable" and "no ...
Hi guys,is there any way how can I shutdown embedded ap from the host router, please (891 platform)? I need a simple eem applet that shuts dot radio interface every day from midnight till 6 am... problem is that AP does not support eem. So I need to ...
Hi Team,I have one issue with WCCP redirection inside VRF. Here is my scenario:PE router config (MPLS edge)-------------------------------------------ip vrf aaa rd 10:1 route-target both 10:1!int facing CE router ip vrf forwarding aaa ip address x.x....
Hi Team,I have one question regarding switch sg300-10. How can i check current interface utilization in bits/second, please? If I use show int counters I can only see number of unicast, broadcast and multicast packets....plus total packets. But there...
Hi Jeff,thanks for your answer.In your post, there is configuration of SSH service on the WAAS (when connecting TO the WAAS box).I was asking my question regarding SSH client (when connectiong FROM the WAAS box). If it is possible to turn it off and ...
Hi Naveen,well using two default routes with different AD will not work...router will just install the one with the better AD and use it as the primary path. Use policy based routing as it routes based on the source IP address...Rgrds,StanSent from C...
Thanks Joseph,I used approach with "service-module wlan-ap 0 session" and then used particular commands to shut down radio interfaces.The problem was that I used ssh approach after I had realized that ap does not support eem localy... so I tried to s...
Hi Dave,Thanks for your reply.I will try to go with RMON but I really hope that this feature will be implemented in the future release of the code.Rgrds,StanSent from Cisco Technical Support iPad App
