Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I should install an ACI fabric shortly, but my Spine switches order is delayed for some time.
So in the meantime, may i use 2 x N9K-C93180YC-EX border leafs, plus other two leaf switches of the same model meshed with 40Gbps interfaces to bui...
Hi,
I need to integrate two legacy Fabrics (Brownfields) at L2 to an ACI fabric tenant to migrate bare metal equipment into it.
Both legacy fabrics are now running isolatedly, and present some degree of vlan overlapping since in some cases each ...
Hello,In a BGP autonomous system with several Route Reflector clusters into it, should all BGP clusters be fully Meshed?I read design docs of hierarchical RR architectures, where a backbone RR cluster is the hub of several “spoke” regional RR cluster...
HelloIs it possible to deploy a Fast Reroute (FRR) backup tunnel terminating in a node several next-hops downstream instead of just one?All the examples i found in the documentation about FRR Node Protection, -or NNHOP-, always illustrates one protec...
Hello FWSM experts,An FWSM V4.1 blade is operating with 15 ip interfaces, each one with its specific access list. The security managers say that maintaining a single ACL instead of 15 would represent a significant improvement. For that reason they su...
Cisco ACI Fundamentals V1.1, section "Per Port VLAN" says: "Starting with the v1.1 release, multiple EPGs with the same VLAN encapsulation can be deployed on a given leaf switch (or FEX), as long as the EPGS are associated with different bridge doma...
Many thanks for your valuable aswer.
Just for my information, regardind your second example: Could i, for instance, terminate the incoming vlan100 of Brownfield #1 as is in a leaf; and remap the incoming vlan 100 of Brownfield #2 to another vlan-id ...
Thank you for your answer.The ASA is an 5540 which includes 4 embedded GigabitEthernet only. With the AIP SSM inserted in the slot. The current configuration diverts all traffic to the SSM. Which is configured as inline, fail-open mode: access-list I...
Thank you for your answer.In such case, can i deploy the FWSM in routed mode between vlans with MSFC SVI interfaces assigned to different VRFs? For instance, can i assign the FWSM outside interface to a vlan in which there is also an MSFC SVI assigne...
