Hi,I have a 6500 switch with Sup2 and MSFC2 card on it. The switch is running in the Native IOS mode. I am supposed to upgrade the IOS such that the new IOS has to support the VRRP.The switch is presently having the IOS version 12.1(26) and similar v...
Hi,I have a scenario in which I need to configure IPSEC VPN as a failover to the existing MPLS connection between any branch and the HO.My question is how do I give more priority to the routing traffic and less priority to the VPN traffic. The tunnel...
Hi,I have a scenario in which I have two different sites and two different links between them. The primary link is a leased line and secondary link is through the VPN using the internet. I want to condifure the VPN as the failover for the LL. Can any...
Hi,Can any one suggest me how to configure load-balancing and failover between ASA and multiple ISPs. All ISP connections is terminated on a single router.Thanks and regards,SH.
Hi Marshall,Thanks for the reply.We have a router at the branch upon which both the MPLS and the internet connections are being terminated. In case of MPLS failure all the data going out to the internet will be encrypted after the tunnel is formed. E...
Hi Jerry,The problem is that routed traffic uses the routes and the VPN uses the ACL. I am not sure how to give more priority to routed traffic and less priority to the VPN traffic. Regards,SH.
Hi,I have ASA at the HO and a router at the branch. Both the sites are connected to the internet separetly and have a leased line between them.This same scenario will grow further, with many branches trying to connect to the HO using VPN. The leased ...
Hi,Yes, this is very much possible. While configuring the VPN you need to specify the interface to which the tunnel belong to and the peer ip address. You have to select the respective interface for the IPSEC traffic to flow. Regards,SH.