Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
do we need to have targeted LDP neighborship over backup FRR tunnel... ?FRR between P & PE...Tunnel from P to PE , if LDP is not configured Tunnel will work fine since PE can understand the VPNv4 label.Tunnel from PE to P, LDP is a must since P canno...
following sw interface is not showing input/output flow of traffic.... any ideas....?SW.ISBTHQ.ASW01#sh int gig 1/48 GigabitEthernet1/48 is up, line protocol is up (connected) Hardware is Gigabit Ethernet Port, address is 0022.55be.93ff (bia 0022....
R1 has a loopback interface (1.1.1.1/32) which it is redistributing into OSPF with metric-type E2... since metric doesnot change throughout the network with type E2, RO should have two paths for 1.1.1.1/32 one directly to R1 and other one through ...
topology : R1----R2----R3- route x.x.x.x is connected on R2 and y.y.y.y on R3 and advertised in ospf through network command...- sh ip route x.x.x.x or y.y.y.y on R1 reveals that this route has metric 20 and is an intra-area route (so no chances ...
Dear Antonio,thank you for your reply... you are right.. i got the same clue while researching the concept...but a little modification in your explanation... "the FRR tunnel doesn't need to have LDP enabled, since it will just be used to swap the pr...
just read this on cisco.com...this explains the phenomenaThe easiest conditional default route origination is configured with the default-information originate router configuration command without the always option, which will advertise an external d...
here are the configs from live network:interface on which R1 is connected to R2.. the route is 10.171.5.0/24 behind R2R1#sh ip ospf interface gigabitEthernet 1/0/19GigabitEthernet1/0/19 is up, line protocol is up (connected) Internet Address 10.17...
