I have configured the CISCO FP MC VMware Virtual Appliance with the initial IP management address settings and I'm unable to access the Web GUI. I can ping the IP (I can see packets arriving on the FP MC via tcpdump) and when trying to access via htt...
hi folks,
I have 3 2960 CISCO switches, the default STP mode is PVST.
Ports F0/2 and F0/4 on all 3 switches are enabled and configured as trunk ports, all other ports are in shutdown state.
VLAN 1
The priority on all 3 equals to the default of 3...
hi guys,
I want to take the CCENT exam prior to CCNA, but I'm struggling to find what's covered in the exam.
I've found this:
https://learningnetwork.cisco.com/community/certifications/ccna/icnd1/exam-topics
I'm just puzzled, because I'm enrolled...
hi guys,
I'm wondering why we have to use the access-class command to apply an ACL to a VTY line to restrict telnet / ssh access. I know that the VTY's are in software and are not physically bounded to a particular interface but wouldn't be placing ...
So, the tunnel interface IP's can be set to whatever I want , I guess, right ?
Considering this simple scenario, where I want to ping from Laptop1 at 129.168.2.2 to Laptop0 at 192.168.1.2 through a GRE tunnel, the tunnel interfaces are not presen...
Thank you Richard. I get your points. So say, I have a router with on LAN attached to it. The, say Gig0/1 interface has the 192.168.0.1 255.255.0.0 address assigned to it. So I enable OSPF specifying not the network address with wildcard mask but 192...
So, if I want to advertise OSPF routes across the Internet via GRE tunnel and the network that I want to advertise is 192.168.0.0 /16 the IP assigned to the tunnel interface could be from that range, e.g. 192.168.255.100, right ?