Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Networkers,I would like to know whether there is any mechanism to monitor route , the reason is when we have a link flap on the primary circuit normally the traffic flows through backup circuit but when there is continous flap on primary circui...
Hello All, I have a query , we have enabled ip route cache flow on the main ATM IMA interface and we have few subinterfaces configured in it.While looking at the output of ip cache flow I see the source IP add & source interfaces to be different i.e....
Hello All,I would like to understand the root cause for ignored packets , I have a 2811 router with 2 FE I'm seeing input erro /ignored packet count increasing on one FE which is connected to the service provider - 30 Mbps Ethernet circuit.As per...
Hello all,Would like to know whther the below setup works ??Primary connection :Site C connected to Site B ( point-point)Site B connected to Site A ( point-point)Secondary connection:Site C connected to Site B (ISDN)Site B connected to Site A (ISDN)N...
Hello all,I have a problem with one of my frame relay circuit.Im not seeing any errors on the physical link , Im getting gud response when i ping the LAN ip ranges on both the side.But my question here is when I ping the Serial Ip's of this Frame rel...
Hello Giuseppe,I went through the doument and it fits to my requirement , Will test this in GNS3 and will seak your help if needed , thanks again.Raghavan
Hello Giuseppe,Thanks for your response , I just browsed on this command but I was not able to find how to relate this logs and acheive my requirement that is if there is any route flap on primary link it should not revert the route back to the prima...
Please correct me if I'm worng , EEM is a proactive event managemnet tool which does only notification ?? whereas my requirement is that the protocol should make a decision before selecting a preffered route.Is there a way in EEM ??
